Kohler CV1000 Manual de usuario descargar pdf (Pagina 89)

8.13

Section 8

Disassembly

Figure 8-52. Removing Oil Pan.

Oil Pump Assembly

The oil pump is mounted to the inside of the oil pan.

If service is required, refer to the service procedures

ȱȁȁȱȱ¢ȂȂȱȱȱşǯ

Remove Camshaft

ȱ ŗǯȱ ȱȱĞȱȱȱǻȱǼǯȱȱ

ȱŞȬśřǯ

Figure 8-53. Removing Camshaft.

Remove Connecting Rods with Pistons

and Rings

ŗǯȱ ȱȱȱ¡ȱĚȱȱȱȱ

closest connecting rod end cap. Remove the end

ǯȱȱȱŞȬśŚȱȱŞȬśśǯ

Figure 8-54. Removing Connecting Rod Screws.

NOTE: If a carbon ridge is present at the top

of either cylinder bore, use a ridge

reamer tool to remove the ridge before

Ĵȱȱȱȱǯ

Figure 8-55 Remove Connecting Rod Caps.

NOTE: The cylinders are numbered on the

crankcase. Use the numbers to mark

each end cap, connecting rod and piston

for reassembly. Do not mix end caps and

connecting rods.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 137 138

Sin comentarios

Kohler CV1000 Manual de usuario Pagina 89