
Table of Contents
IMPORTANT SAFETY INSTRUCTIONS ................................................ 2
Product Information ............................................................... 2
Electrical Requirements .......................................................... 2
Product Notices ................................................................ 2
Factory Assembled Features ...................................................... 3
Connections and Service Access ................................................... 3
Tools and Materials ............................................................... 4
Before You Begin ................................................................. 4
Construct the Site - Wood Frame ..................................................... 6
Construct the Site - Concrete ........................................................ 7
Secure the Bath .................................................................. 8
Install the Plumbing ............................................................... 9
Connect the Electrical Service - Standard .............................................. 10
Remove the Blower Motor and Check Valve - Remote ..................................... 11
Mount the Blower Motor and Check Valve - Remote ...................................... 12
Terminate the Blower Power Cable - Remote ........................................... 13
Install Blower Power Cord at Control - Remote .......................................... 15
Make Supply Power Connections - Remote ............................................ 16
Complete the Installation .......................................................... 17
Test Run the Bath ............................................................... 17
Operate the Keypad .............................................................. 20
Troubleshooting ................................................................. 21
Tools and Materials
Before You Begin
CAUTION: Risk of product damage. Do not lift the bath by the piping or blower motor, or use the
piping or blower motor for structural support of the bath.
NOTE: This bath allows the blower motor and check valve to remain on the bath support board (standard
installation) that it is shipped on or to be relocated to another location (remote installation). Refer to the
sections, noted as ″Standard’ or ″Remote,″ throughout this installation guide for your applicable
installation.
For Standard and Remote Blower Installations
Silicone Sealant
Plus:
• Conventional woodworking tools and materials or
conventional masonry tools and materials,
as appropriate
• Drop cloth
• Construction Adhesive (optional)
• Cement or Mortar (optional)
• 2x4s or 2x6s (optional)
1035472-2-J 4 Kohler Co.
Comentarios a estos manuales