Kohler K-10280-4A-CP Guía de instalación descargar pdf (Pagina 3)

1. Install the Spout

Remove the temporary nipple from the bath elbow.

CAUTION: Risk of internal seal damage. Loosen spout setscrew

with a 5/32” hex wrench prior to installing the spout.

CAUTION: Risk of internal seal damage. Do not use

petroleum-based lubricants. If spout will not slide over tubing,

use soapy water or a silicone-based lubricant.

Slip-Fit Spout

Apply thread sealant and install a 1/2” copper tube to extend

between 2–1/8” (5.4cm) and 3–1/2” (8.9cm) beyond the ﬁnished

wall.

Deburr the copper tubing.

Loosen the setscrew with a 5/32” hex wrench.

Apply plumbers putty or other sealant, according to the putty

manufacturers instructions, around the base of the escutcheon,

leaving a small gap free of putty at the bottom of the escutcheon.

Install the spout and carefully retighten the setscrew. Do not

overtighten the setscrew.

Remove any excess putty.

Kohler Co. 3 1018256-2-A

1 2 3 4 5 6 7 8 ... 15 16

Sin comentarios

Kohler K-10280-4A-CP Guía de instalación Pagina 3